Cooper Security i-on160EX Guía de usuario descargar pdf (Pagina 93)

i-on160 4. Administration

Page 87

7. Press Y.

REMOTE

Edit >

8. Press n until the display

shows:

REMOTE

Delete All >

9. Press Y.

The display shows:

(Press X if you decide you do

NOT want to delete all

remotes.)

DEL ALL REMOTES

Are you sure?

10. Press Y.

All Remotes

Deleted

followed by

SYSTEM CONFIG

Remotes >

11. Press X repeatedly to leave the

menu.

To register remote controls with users once again enter the Menu

and select Users - Edit User (see page 42).

Starting a Call To Downloader

Note: This option is available only if you have the appropriate

communicator module fitted inside the control unit and it

has been programmed by the installer. You can use the

About menu to check if you have a communication module

fitted, see page 91.

Your installer may be using a personal computer connected to the

telephone network in order to program your alarm system. The

software the Installer uses to program your alarm system is

called Downloader.

There may be times when your Installer asks you to make your

alarm system start a telephone call out to the installer's

Downloader. Your alarm system is programmed to call two

different telephone numbers. You do not have to know these

numbers, your Installer will tell you to select one of them.

To start the call:

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 103 104

Sin comentarios

Cooper Security i-on160EX Guía de usuario Pagina 93