Cooper Security i-on160EX Guía de usuario Pagina 7

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 104
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 6
i-on160
Page 1
1. Introduction
The i-on160EX is an intruder alarm system intended mainly for
use in commercial properties.
The heart of the i-on160EX system is the control unit, its
expanders and keypads.
The control unit contains the main processing unit, the power
supply and stand-by battery. The stand-by battery can keep the
alarm system going for a few hours if the mains supply fails.
Connected to the control unit by cable are the expanders and
keypads. The expanders provide extra connection points for
detectors, either wired or radio. The keypads each have a two line
display to show you status information, and various keys for
operating the system. The keypads also contain a speaker to give
warning tones when the system is setting or unsetting.
Users identify themselves to the system by keying in access
codes. If they do not wish to use access codes then the keypads
also contain proximity tag readers, allowing users to identify
themselves by means of small electronic tags that they carry with
them.
To protect an area the control unit can operate a range of
detectors. Detectors can be connected to the control unit or
expanders by wires, or communicate to a radio expander using a
small radio transmitter. Figure 1 shows some examples. In
addition to fixed detectors the control unit can also monitor small
portable transmitters that users can employ to start alarms
remotely, for example in the case of a panic alarm.
When the control unit detects an alarm, it can start an external
sounder/strobe unit by sending the appropriate radio signal. In
addition the control unit can also communicate using a variety of
plug on modules. Some modules also provides speech recording
and playback facilities so that the system can send recorded
speech messages to pre-programmed telephone numbers.
The control unit and expanders also provide sets of connectors for
outputs, which the installer can use to link the control unit to
siren/strobe units or other equipment.
Vista de pagina 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 103 104

Comentarios a estos manuales

Sin comentarios