Cooper Security i-on160EX Guía de usuario descargar pdf (Pagina 81)

i-on160

Page 75

Programming Outputs

During programming the installer may allocate some outputs so

that they can be reprogrammed by an Administrator. This section

describes how the Administrator can use those outputs.

For each output you can, if you wish, set and “on” time and an

“off” time so that the output will go on and off at fixed times each

day. In addition, Master, Admin and Normal users can switch the

output on or off at any time.

To program an output:

1. Make sure the display shows

the standby screen.

i-on160EX

12:20 02/11/2010

2. Press .

Enter Access Code

( )

3. Key in your access code (or

present a tag).

Omit Zones >

4. Press n until you see:.

System Config >

5. Press Y.

The bottom line of the display

shows:

SYSTEM CONFIG

Facilities On/Off >

6. Press n until the display

shows:

Note: This option is only visible if

the installer has allocated

some outputs to you.

SYSTEM CONFIG

Edit Outputs >

7. Press Y.

The top line of the display

shows the physical address of

the first in a list of outputs that

are available to edit. The

bottom line shows the name of

the output (if the installer has

given the output a name).

EDIT O/P W1>02>01

O/P W1>02>01 >

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 103 104

Comentarios a estos manuales

Sin comentarios

Cooper Security i-on160EX Guía de usuario Pagina 81

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Cooper Security i-on160EX