3. Installation 9752 Installation Guide
Page 36 11976870
Notes:
1. With software versions earlier than 5.xx.xx key in 0 followed by the
default Engineer Code 7890.
2. You do not have to remove the case lid.
The display shows:
Installer Mode
You are now in installer (programming) mode.
The Programming Guide explains how to program the system. Cooper
security recommend that at this point you return the system to its default
settings using Command 98. See Restoring Default Command Settings in
Chapter 1 of the Programming Guide.
Note: You will also need to let the expanders learn the wirefree detectors, and
then install the detectors at their selected sites.
Comentarios a estos manuales