Cooper Security 9752 Guía de instalación descargar pdf (Pagina 20)

3. Installation 9752 Installation Guide

Page 16 11976870

Fitting the System

Fitting the Control Unit Case

1. Remove the control unit case from its packaging.

2. Remove the front screws and slide off the case lid.

3. The upper part of the case back has a central keyway. Mark and drill a

hole for the keyway. Temporarily fix the case back to the wall. Mark the

position of two more fixing holes, remove the case back and drill the

holes.

4. Refit the case back to the wall using screws no less than 30mm x No 8,

with dome or pan heads.

Fitting a 9941 or 9943 Keypad

Note: If you are fitting more than one 9943 keypad to a control unit then make

sure that there is at least 1m distance between individual 9943 keypads.

Beware of mounting 9943’s back to back on opposite sides of a wall.

When 9943 keypads are closer than 1m to each their prox tag readers

interfere, and neither keypad can read prox tags.

Figure 5 shows the backplate and the position of mounting holes.

1. Cable entry. 3. Back tamper aperture.

2. Fixing holes. 4. Sounder aperture.

Figure 5. Backplate of the 9941/9943 Keypad

Cooper Security recommend that you mount the keypad using No 8 or 6

screws (M4/M3.5) as follows:

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 43 44

Sin comentarios

Cooper Security 9752 Guía de instalación Pagina 20