Cooper Security Homelink 75 Guía de usuario descargar pdf (Pagina 26)

Programming Reference - Detectors 7510r

Page 22

Exit Normal Alarm

A zone programmed as ‘Exit Normal Alarm’ behaves

similarly to a Normal Alarm zone. However, a zone of

this type will start an alarm if the detector is

triggered during the exit time.

Partitions and Zones

When you first teach a detector to the control unit then

the zone defaults to partition 1.

You can assign zones of the following type to one or more

partitions: Normal Alarm, Final Exit, Entry Route, Key

Box, and Exit Normal Alarm.

Note: If you intend to use part set partitions then make

sure that for any zone shared by more than one

partition the part set options are all the same.

The control unit will not allow you to assign zones of the

following types to more than one partition: 24 Hour, Fire,

Panic Alarm, and Technical.

Zone Attributes

The attributes available are:

Chime

When enabled by the user, the system gives a non-

alarm warning tone when any zones programmed as

‘Chime’ are opened. This facility operates only while

the system is unset.

Soak Test

Use this zone attribute if you want to place under

long term test a detector that you suspect is giving

false alarms. Zones with this attribute are disabled

for 14 days after you return the control unit to user

mode. If the zone is activated while the system is set

then the control unit logs the event as a “Soak Test

Fail Zn” (n is the zone number) without sounding any

sirens or starting signalling. After midnight on the

14th day the control unit returns the zone to normal

use.

Activity Monitoring

While a partition holding a zone with this attribute is

unset, the control unit starts a Social Care Alarm if

the detector has not been activated for a set time.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 83 84

Sin comentarios

Cooper Security Homelink 75 Guía de usuario Pagina 26