Cooper Security Homelink 75 Guía de instalación descargar pdf (Pagina 22)

Administration

Page 22

During programming the installer may allocate some

outputs so that they can be reprogrammed by an

Administrator. The following section describes how the

Administrator can use those outputs.

Programming an Output Channel

If you wish to program an output that an installer has

allocated for use by an Administrator:

1. In the User Menu select System Config - Outputs -

Edit Output.

The display shows the Edit Output menu, with a list

of the outputs.

2. Select the output Channel you wish to edit

The display shows a menu that allows you to

change the name of the selected output, and to set

an “On” and “Off” time for the output.

3. Select Name to give the output a meaningful name.

The keypad allows you to enter letters as shown in

Figure 3.

The name you give the output appears in all the

other menus the display offers for controlling

outputs.

4. Select “On Time” to set a time when the control

unit will switch the output on. Select “Off Time” to

set a time when the control unit will switch the

output off. If you do not wish the output to switch

on and off at set time then leave these two options

set to “00:00”.

Note: You can switch the output on and off from the User

Menu by selecting Outputs On/Off (see page 28).

If you want to program a telecommand to control

the output, see page 23.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 31 32

Sin comentarios

Cooper Security Homelink 75 Guía de instalación Pagina 22