Cooper Security i-on16 Guía de instalación descargar pdf (Pagina 60)

4. Administration i-on16

Page 60

6. Press  until you see:





7. Press .

The bottom line of the display

shows the first in a list of the

outputs allocated for your use.

If the output has a name

programmed for it, that will

appear on the bottom line

instead of the output number.





8. Press  or  to display the

output you wish to test.





a). Press .

The keypad gives a double

“beep” confirmation tone. The

keypad display shows:

The control unit turns on the

output. Check that that it is

working as expected.

Note: Outputs connected to radio

output modules may take

several seconds to change

state.





b) Press  again to turn the

output off.





9. Press  to end the test.





NOTE: Make sure no one tries to activate an output by means of

a remote control while you perform the test.

When you complete the test check that the output is back

in the state it had before testing. For example, if the output

was off before testing, make sure it is off after testing.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 89 90

Comentarios a estos manuales

Sin comentarios

Cooper Security i-on16 Guía de instalación Pagina 60

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Cooper Security i-on16