Cooper Security i-on 16 Guía de usuario descargar pdf (Pagina 23)

Administration

Page 21

If you do not wish to register a remote control press X.

If the control unit has already learned that remote control then

you will hear a low tone and the display tells you that the remote

control is already in use.

If you have a remote control and want to know who it belongs to

then use the Test - Remotes menu option, see page 24 .

Panic Alarms (PA)

A PA is a two button transmitter, used to start a Panic Alarm. To

activate the transmitter you must press both buttons at the same

time. On some models a third button acts as a lock so that you

can prevent the PA going off when carrying it in your pocket.

Note: While you are registering a new PA the control unit will not

respond to an alarm signal from any PA it has already

learned.

To allocate a panic alarm to a user, select Users - Edit User - User(nn)

- Panic Alarm.

Note: If the user already has a PA allocated to them then the

screen will display “Delete PA?”. See “Deleting Remote

Controls, Tags and PAs” below.

The display asks you to press both buttons on the PA.

1. Squeeze both buttons on the PA.

When you squeeze the buttons the control unit learns the

identity of the PA and registers it to the user.

If you do not wish to register a PA press X.

You cannot register more than one PA per user. If the control unit

has already learned that PA then you will hear a low tone and the

display remains unchanged, asking you to press the buttons on

the PA.

If you have a PA and want to know who it belongs to then use the

Test - Panic Alarms menu option, see page 24 .

Deleting Remote Controls, Tags and PAs

If a user has lost a remote control, prox tag or panic alarm then

you should delete it from the system to make sure that no

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 31 32

Sin comentarios

Cooper Security i-on 16 Guía de usuario Pagina 23