Cooper Security i-on 16 Guía de instalación descargar pdf (Pagina 18)

i-on40

Page 14

3. Identify the Reset Codes pins on the

main PCB (see Figure 3).

4. Short the Reset Codes pins together

using a screwdriver or jumper link.

(Keep the short on until step 6.)

5. Apply mains power.

The control unit loads the factory default

access codes:

User 1: 1234, Installer: 7890.

After a short pause the keypad display

shows the time and date. The red LEDs

glow to show an alert that the panel lid

is open.

The system may start a tamper alarm.

6. Remove the short from the Reset Codes

pins.

7. Reconnect the battery.

8. Close the end station lid (to restore the

tamper switch).

9. Key in 1234 to silence the sirens (if

necessary).

Press Y twice (if necessary) to

acknowledge any alerts.

If the red LEDs around the navigation

key still glow then there may be an alert

for a missing battery that needs

acknowledgement. To force the end

station to check the battery:

10. Enter Installer Menu and then leave it

again.

11. Press Y, key in 1234, press Y again.

The navigation key LEDs should now

glow green.

Restoring Factory

Defaults

If you wish to restore all factory default

options then:

1. From the Installer Menu select System

Options – Restore Defaults – Factory Defaults.

The display asks for confirmation.

2. Press Y to load defaults.

(Press X to go back to the Installer

Menu without changing defaults.)

The display asks you to select Partition

Mode or Part Set Mode.

3. Press A or B to select the desired mode.

The display asks you to select the zone

wiring type.

4. Press u or n to display the desired

wiring type on the bottom line of the

display and then press Y to select it.

The system loads all defaults except for

Access Codes and the Log (see Note).

The display returns to the Installer

Menu.

Note: The log is protected and cannot be

erased by the Installer.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 27 28

Comentarios a estos manuales

Sin comentarios