
FOB-2W-4B
Page 2
2. Lift off the battery lid.
3. Fit the new battery. The positive side of the battery should be
on top. Note: make sure your hands are clean and dry when
handling the battery. Even small amounts of grease or dirt can
affect the contact between the battery and the fob.
4. Re-fit the battery lid.
5. Hold the key-ring shackle in place and re-fit the screw you
removed in step 1.
6. Tighten the screw until it holds the battery lid closed. Do not
over-tighten the screw.
7. Test the new battery by holding down the Query button on the
fob for three seconds (see figure 2). You should see the red LED
by that button flashing.
A Guided Tour
When you receive your fob for the first time, take a minute to
look at it and identify each of the buttons. Figure 2 shows you
where they are.
Figure 2.
Part Set button
(or
programmable)
Comentarios a estos manuales